Using the manual execution assistant

Mark each manual test case step as passed or failed and move through a test set using the manual execution assistant.

The manual execution assistant guides you through a set of manual tests one after another. You need to set a result on each manual step to advance to the next test case in the test set. Through the Manual Execution Assistant, you need to treat and mark steps in each case either as passed or failed.

If the test case has a description, it appears before Precondition in a collapsible Test case description panel. You can select the panel to expand the full text without leaving the execution window.

Abbildung 1. Ausführen von manuellen Tests mit dem Assistant für die manuelle Ausführung

Schritte

1. To mark the progress of each step in the test case, select Set Failed or Set Passed. For test cases with multiple steps, you set the result of each step individually.

   

2. In the Tester comment section, add comments, especially when marking a step as failed, to supply specific information about the outcome.

3. After marking a step, select Set Passed Until Here to set the following steps as passed.

4. Once you conclude a test case by assigning a result to the last step, select Next. This action advances you to the next test case within your test set.

5. Wiederholen Sie die Schritte eins bis vier, bis Sie den letzten Testfall im Testsatz erreicht haben.

6. Verify the postcondition, if one is specified for the manual test, after assigning a result to the last step of a test case.

   1. Wenn die Nachbedingung erfüllt ist, wählen Sie Bedingung erfüllt aus.
   2. Wenn die Nachbedingung nicht erfüllt ist, lassen Sie Bedingung erfüllt nicht ausgewählt.

7. Wählen Sie nach Fertigstellung des letzten Testfalls Fertig aus, um den gesamten Ausführungsprozess abzuschließen.

Ergebnis

All test cases in the test set are marked as passed or failed, and the execution process is complete.