Using the manual execution assistant

Mark each manual test case step as passed or failed and move through a test set using the manual execution assistant.

The manual execution assistant guides you through a set of manual tests one after another. You need to set a result on each manual step to advance to the next test case in the test set. Through the Manual Execution Assistant, you need to treat and mark steps in each case either as passed or failed.

If the test case has a description, it appears before Precondition in a collapsible Test case description panel. You can select the panel to expand the full text without leaving the execution window.

Figura 1. Ejecutar pruebas manuales utilizando el Asistente de ejecución manual

Pasos

1. To mark the progress of each step in the test case, select Set Failed or Set Passed. For test cases with multiple steps, you set the result of each step individually.

   

2. In the Tester comment section, add comments, especially when marking a step as failed, to supply specific information about the outcome.

3. After marking a step, select Set Passed Until Here to set the following steps as passed.

4. Once you conclude a test case by assigning a result to the last step, select Next. This action advances you to the next test case within your test set.

5. Repite los pasos uno a cuatro hasta llegar al caso de prueba final en el conjunto de pruebas.

6. Verify the postcondition, if one is specified for the manual test, after assigning a result to the last step of a test case.

   1. Si se cumple la condición posterior, selecciona Condición cumplida.
   2. Si la condición posterior no se cumple, deja Condición cumplida sin seleccionar.

7. Después de finalizar el último caso de prueba, selecciona Listo para completar todo el proceso de ejecución.

Resultado

All test cases in the test set are marked as passed or failed, and the execution process is complete.