Configurar la conectividad privada

This section outlines the UiPath-specific configuration. For Azure portal steps, use Microsoft documentation.

1. Create the private endpoint

Create a Private Endpoint in the VNet where your client workloads run.

Use the following configurations for the endpoint:

• Connection method: Connect to an Azure resource by resource ID or alias
• Resource ID: Use the value from the Available regions section.
• Target sub-resource: Use the Subresource value from the regional table

For detailed Azure instructions, refer to Create a private endpoint by using the Azure Portal.

After the endpoint is created:

1. Record the private IP address assigned to the endpoint.
2. You will use this IP address when configuring DNS.

Nota:

After the private endpoint allocates a private IP, make sure your firewall rules allow traffic from your VNet to that IP address.

2. Configure the Private DNS zone

Your VNet must contain a Private DNS zone for cloud.uipath.com. This ensures traffic resolves to the private endpoint instead of the public endpoint.

1. Create the Private DNS zone, using the steps detailed in the Microsoft documentation.

2. Link the cloud.uipath.com Private DNS zone to the VNet where the private endpoint exists. For step-by-step guidance in Azure, refer to the Microsoft documentation.

3. Add the following A record to your cloud.uipath.com Private DNS zone:

   Record name	Tipo	TTL	Valor	Notas
   @	A	100	<Private endpoint IP address>	Use the private IP assigned to your endpoint

4. After configuring DNS, validate that:

   • cloud.uipath.com resolves to the private endpoint IP from your client subnets.
   • Clients can authenticate and access Automation Cloud through the private endpoint. If DNS is misconfigured, traffic may fail to connect or may route traffic to the public endpoint.

Importante:

• The @ record must point to your private endpoint IP.
• You are responsible for maintaining this DNS record in your environment.

3. Request private endpoint approval

After completing the private endpoint and DNS configuration:

1. Póngase en contacto con el soporte técnico de UiPath.
2. Request approval of your private endpoint connection.

The endpoint remains in a Pending state until UiPath approves it from the Application Gateway side.

Once approved, the connection status changes to Approved, and traffic flows through the private connection.