Linking Test Cases in Studio to Test Manager

You can link a test case in Studio to a correspondent test case and requirement in Test Manager. To complete this action, you need to integrate Studio to Test Manager.

1. In Studio, open an existing project or create a new Test Automation.
2. Open an existing test case or create a new one.
3. In the Project, right-click a test case and select Link to Test Manager. Alternatively, you can use Ctrl + Click for multiple selections to link multiple test cases to a requirement.

   :grey-exclamation: Test Manager might require you to sign in, using your credentials.

4. Configure the test case information:
   • Project: Select your project. If you did not set a default project for Test Manager, see Integrating with Studio.
   • Test: Select a test case from the dropdown list.
   • Name: Enter a name only if you create a new test case in Test Manager.

   • Requirement: . Leave this field blank if you create a new requirement. The name is read-only in Test Manager. Alternatively, you can select a Requirement from the dropdown list if you want to assign the test case to a specific requirement in Test Manager.

     
     

     

     
     
5. Click OK to confirm.
   Tip:

   • To open the newly created test case in Test Manager, go to Test Manager > Open Test.
   • To unlink the automation from the test case, navigate Test Manager > Unlink Test and then click Yes to confirm changes. You can unlink it all together by opening the test case and navigating to Automation > Unlink Automation.